UC500-D1-3K-V7
Артикул: 212371
Ultrasonic sensor
24 247 Р
Производитель:
PEPPERL+FUCHS
Поделиться:
Производитель: PEPPERL+FUCHS
Краткое описание: технические характеристики UC500-D1-3K-V7
| Описание оборудования | ||
|---|---|---|
| Single head system | ||
| General specifications | ||
|---|---|---|
| Sensing range | 60 ... 550 mm | |
| Dead band | 0 ... 60 mm | |
| Standard target plate | 100 mm x 100 mm | |
| Transducer frequency | approx. 380 kHz | |
| Response delay | > 10 s, relay < 1 s, LEDs |
|
| Indicators/operating means | ||
| LED red | LED 1: overfill indication LED 4: underfill indication |
|
| LED green/yellow | LED 2: overfill warning and normal operation LED 3: normal operation and underfill warning |
|
| DIP switch | setting of the switch points/operating modes | |
| Electrical specifications | ||
| Operating voltage | 10 ... 253 V DC 20 ... 253 V AC , 47 ... 63 Hz |
|
| No-load supply current | < 30 mA with UB = 30 V DC < 110 mA at UB = 10 V DC < 25 mA at UB = 220 V AC |
|
| Output | ||
| Output type | 3 relay outputs, normally open/closed, selectable | |
| Range hysteresis | 20 mm | |
| Contact loading | 253 V AC/150V DC, 3 A (ohm. load) | |
| Life span | electrical: 105 switching cycles with ohmic load (3 A/253 V AC or 3 A/30 V DC) minimum contact load: 100 µA/100 mV DC mechanical: 20 x 106 switching cycles |
|
| Temperature influence | < 4 % | |
| Fusing | ≤ 3 A Slow-blow fuse per output in accordance with IEC 60127-2 Sheet 5 required. Recommendation: after a short circuit, check that the device is functioning correctly. | |
| Compliance with standards and directives | ||
| Approvals and certificates | ||
| EAC conformity | TR CU 004/2011 TR CU 020/2011 |
|
| CCC approval | Certified by China Compulsory Certification (CCC) | |
| Ambient conditions | ||
| Ambient temperature | -20 ... 60 °C (-4 ... 140 °F) | |
| Storage temperature | -40 ... 85 °C (-40 ... 185 °F) | |
| Mechanical specifications | ||
| Degree of protection | IP65 | |
| Connection | Female connector, V7 (7-pin), 90° Wire cross section: ≤1.5 mm2 cable diameter ∅7 ... 9 mm |
|
| Material | ||
| Housing | cover: PC housing: PBT threaded flange: stainless steel installation connector/cable socket: PETP |
|
| Transducer | epoxy resin/hollow glass sphere mixture; polyurethane foam | |
| Mass | 700 g | |
| Note | In case of loss or damage, the cable socket must be replaced by an identical cable socket (type V7-W) from Pepperl+Fuchs! | |
Оформить заказ на UC500-D1-3K-V7 вы можете в компании compeq-pepperl отправив заявку по почте, а также по телефону или в офисе компании.
Вам может понравиться
