NJ40+U2+E2

Артикул: 017704

Inductive sensor

5 089 Р

Заказать

Производитель:

PEPPERL+FUCHS

Получить консультацию

Производитель: PEPPERL+FUCHS

Технические данные PDF

Краткое описание: технические характеристики NJ40+U2+E2

General specifications
Switching function		Normally open (NO)
Output type		PNP
Rated operating distance		40 mm
Installation		non-flush
Output polarity		DC
Assured operating distance		0 ... 32.4 mm
Reduction factor r_Al		0.5
Reduction factor r_Cu		0.45
Reduction factor r₃₀₄		0.8
Output type		3-wire
Nominal ratings
Operating voltage		10 ... 60 V
Switching frequency		0 ... 100 Hz
Hysteresis		1 ... 10 typ. 5 %
Reverse polarity protection		reverse polarity protected
Short-circuit protection		pulsing
Voltage drop		≤ 2.8 V
Operating current		0 ... 200 mA
No-load supply current		≤ 10 mA
Time delay before availability		≤ 100 ms
Operating voltage indicator		LED, green
Switching state indicator		LED, yellow
Compliance with standards and directives
Standard conformity
	Standards	EN 60947-5-2:2007 EN 60947-5-2/A1:2012 IEC 60947-5-2:2007 IEC 60947-5-2 AMD 1:2012
Approvals and certificates
UL approval		cULus Listed, General Purpose
CSA approval		cCSAus Listed, General Purpose
CCC approval		Certified by China Compulsory Certification (CCC)
Ambient conditions
Ambient temperature		-25 ... 70 °C (-13 ... 158 °F)
Mechanical specifications
Connection type		screw terminals
Information for connection		A maximum of two conductors with the same core cross section may be mounted on one terminal connection! tightening torque 1.2 Nm + 10 %
Core cross-section		up to 2.5 mm²
	Minimum core cross-section	without wire end ferrule 0.5 mm² , with connector sleeves 0.34 mm²
	Maximum core cross-section	without wire end ferrule 2.5 mm² , with connector sleeves 1.5 mm²
Housing material		PBT
Sensing face		PBT
Degree of protection		IP68